What better way to show off your allegiance to the Rebellion than with a shining Rebel Alliance logo in the window? Celebrate May the 4th with this simple suncatcher craft that even your toddler or preschooler can help with.
(Good thing it’s a sun-catcher and not a sun-crusher, amirite? *high-fives the other Star Wars Expanded Universe nerds*)
What You Need
Get Started!
Begin by printing this wonderful free Rebel Alliance logo provided by FreeStencilGallery.com. Place the wax paper over the template and use the black Sharpie to trace the logo.
Use the school glue to cover the logo in a thin layer of glue. Don’t worry about keeping it in the lines; feel free to get it outside the lines for the best coverage. You can try glitter glue–you can see I had it in the photo of the ingredients above to try it myself–but I wasn’t satisfied with the results, so I recommend using regular Elmer’s glue.
Next, if you haven’t already, cut a small pile of red tissue paper squares about an inch in length. Place a square in the glue, letting the paper squares overlap (but mostly on the edges).
Keep placing the squares in the glue until the logo is completely covered. Again, feel free to go outside the lines. Those lines will be cleaned up when you cut out the suncatcher shape later.
Allow the glue to completely dry.
Finally, cut out the Rebel Alliance logo from the dried wax paper. You can choose to leave the black outline, or cut just inside the marker line for a cleaner look.
Use the Scotch tape on the side opposite of the tissue paper to stick it on a sunny window.
May the 4th be with you!
This post was last modified on December 2, 2017 11:05 pm
Like many others, I jumped directly into my Apple Music Replay this year filled with…
It's time to stuff the stockings that were hung with care with our must-have stocking…
It's time to get styling and stocking up on everyday necessities that we think you…
Every geek loves a new gadget. Here’s a selection from the GeekDad and GeekMom writers,…
If you enjoy 3D printing with filament and are interested in something new, resin printing…
After spending some time with xTool's M1 Ultra, the other tools in my maker arsenal…